Initialisation & Test
Program 92 Initialising Misc. Backup RAM
2-10
Strata DK40 Programming Manual Spring 1999
Program 92 Overview
Program 92 clears all previously entered or random data (of the type listed) but does not clear
data in system Programs 00~
*
99.
CAUTION!
You must run Program 92 when first installing the system ; if you do not,
the system could begin to operate erratically.
Notes
◆
Running Program 92-5 does not affect digital telephone handset receiver
volume levels. Use Program 27 to set off-hook handset receiver volume levels
for digital telephones.
◆
Program 92-9 does not affect Call Forward External or Fixed Call Forward
settings.
◆
You must power the system OFF then back ON to clear telephone LCD Call
Forward Displays and Call Forward button LEDs. Call Forward memory is
cleared when you run Program 92-9, even if system power is not cycled.
◆
Program 92-81 must be run every time a new PCB is installed or is moved to a
different slot location.
Program 92 Example
Action (press b LED Buttons)
LCD Response
1.
Use the programming LCD electronic or digital
telephone. (
See “Step 1: Check Minimum Hardware
Requirements” on Page 1-18 for more information.
)
No. N-N
1
20 Jan Sun
06:43
2.
-
&
-
&4
-
5
-
6
Enter programming mode. (Do not press [DN] button.)
System beeps after Spkr (Speaker) is pressed to
indicate program number may be entered.
Program Mode
Password = ___________
3.
(QWHU >3DVVZRUG@ +ROG
Enter the four digit password.
level 1 Program Access
4.
6SNU
+
6SHDNHU
, <5
+ROG
Access Program 92.
Program = 92
Data Store
5.
6SNU
+
6SHDNHU
,
Prepare the system for selection of programs to
initialise. For new system installation perform all 1~9.
92 Select =
6.
6HOHFW RQH RI WKH IROORZLQJ
1
4
+ LED Buttons 01 & 03
Clears Station Speed Dial, Voice Mail ID codes, and
LCD memos assigned to station speed dial numbers.
92 Select = 1
Each Dial Clr