System & Station
Program 42-1~8 PBX Access Codes
3-96
Strata DK40 Programming Manual Spring 1999
Program 42-0 Overview
Program 42-0 informs the system which lines are connected to a PBX. This program must be
utilised to allow Toll Restriction and Speed Dialling to function correctly. In addition this
Program is used to allow after recall PBX features to operate on incoming calls. If a line is
programmed for behind PBX (LED ON) waiting, the resieze guard time must be set to 1.5
seconds (Program 10-1 LED2).
Program 42-1~8
PBX Access Codes
Program Type:
Toll Restriction
Initialised Default:
Assigns no access codes to PBX groups
Program 42-1~8 Overview
The system recognises PBX access codes via Programs 42-1 ~ 8. Program 42-0 informs the
software which lines are connected to a PBX This combination allows Toll Restriction and
Speed Dialling to function properly. This program must be utilised to allow after recall PBX
features to operate on incoming calls. Initialised Program 42-0 data reads all LEDs OFF for
all lines. Program 42 initialised data assigns no access codes to PBX groups.
(QWHU 3URJ 0RGH
0
6SNU
7 5
+ROG
0
6SNU
+ROG
0
6SNU
& &
+ROG
0
6SNU
& &
+ROG
PBX Access Code Number
PBX Outgoing Exchange Line Access Code(s)
1st Digit
2nd Digit
1
2
3
4
5
6
7
8
ACCESS CODE = Enter a 2-digit access code for the group, as defined by
the table below.
•
If access code is single digit, enter the first digit and press LED Button 01
as second digit.
•
Press LED Button 01 to delete digit.
•
Press LED Button 02 for Wild Card digit (any digit, 0~9). For example,
pressing
;
+ LED Button 02 allows 80~89.
SELECT = 1~8 PBX Access Code Group
Enter the PBX Group Number 1~8 that needs an
access code assigned.