4-EN
- 4 -
1114370699
Attaching adjust corner caps and air
intake grille
Brand name indication given at factory shipping
Adjust corner cap
* Can be attached at any location.
Indoor unit electrical control box
Wireless Remote Controller Kit
(separate sold parts)
* Can be installed only at this
location.
Refrigerant
pipe side
Drain pipe
side
Omnidirectional 360°
Locations of air intake grille hook knobs
(attached when the product was shipped)
* These knobs can be attached on any
side of the four sides, but attaching
them on this side is recommended.
Attaching air intake grille
• Attach the air intake grille by reversing the procedure of
its removal. The air intake grille of this ceiling panel can
be attached in four patterns by turning the grille. Select
the orientation of the grille for alignment when multiple
ceiling panels are attached or according to customer
requirements.
•
Attach the air intake grille so as not to catch the
louver motor wire.
•
Be sure to attach the safety strap of the air intake
grille to the ceiling panel.
Hook hole of ceiling panel
Safety strap
hook
• According to customer requirements, the grille orientation of
the air intake grille and the location of the company name
indication on the adjust corner cap can be changed as
shown in the figure (right) for installation of multiple units.
However, the Wireless Remote Controller Kit (separate sold
parts) can be installed only at the diagonal corner of the
drain pipe of the indoor unit. If the Kit is installed at another
location, it may cause malfunction of the Kit.
Attaching adjust corner caps
Hook the strap of the adjust corner cap securely to the pin of
the ceiling panel.
Pin
Claws A (insert to
fi
t)
Claws B (press to
fi
t)
Insert the two claws A of the adjust
corner cap into the rectangular holes
of the ceiling panel in the direction of
arrow.
Press the adjust corner cap so that
the three claws B on the back of the
cap are
fi
tted.
Rectangular
holes
Claws A
Claws B
Firmly press edges of the
adjust corner cap.
CAUTION
•
Press the three claws B of the adjust corner cap
firmly as far as they will go, and then check that the
adjust corner cap is closely attached. Failure to do
so may result in water leakage.
3. Other descriptions
Checks after Installation
• Reconfirm that there is no gap between indoor unit and ceiling panel or between ceiling panel and bottom of ceiling.
* Such gap may result in water leakage or dew drop.
• Confirm that all wires are connected correctly and firmly.
* Otherwise, the louver does not work.
• Confirm that the claws of the adjust corner caps are fitted securely.
* Improper fitting may result in water leakage.
When Using Wireless Remote Controller
• For details of the installation, refer to the Installation Manual supplied with the Wireless Remote Controller Kit
(separate sold parts).
Delivery to Customer
• When the installation work has been completed, execute a test run to check for normal operation.
Then explain how to use and maintain the ceiling panel to the customer according to the Owner’s Manual of the indoor unit.
Ask the customer to keep this installation manual with the Owner’s Manual and Installation Manual of the indoor unit.