TOSHIBA 1075000646_EN
3
EN
PARTS NAME
Indoor unit
1
1
1
1
1
Room temperature sensor
2
2
2
2
2
Front panel
3
3
3
3
3
Air inlet grille
4
4
4
4
4
Air filter
5
5
5
5
5
Air outlet
6
6
6
6
6
Horizontal air flow flap
7
7
7
7
7
Vertical air flow flap
8
8
8
8
8
Display panel
9
9
9
9
9
Infrared signal receiver
!
!
!
!
!
Remote control (wireless)
"
"
"
"
"
Remote controller (wired, sold separately)
Display panel
The operating conditions are indicated below.
1.
(OPERATION) lamp (green)
This lamp goes on during operation.
2.
(TIMER) lamp (green)
This lamp goes on white the timer reserved.
3.
(STAND BY) lamp (orange)
This lamp lights up when the power is turned on or right after heating operation starts or during defrost operation and
thermo control.
TEMPORARY button
If you misplace or lose the remote control or its batteries are
exhausted, push the TEMPORARY button.
1. Open the air inlet grille to push the TEMPORARY button.
You can lift the grille up to an angle wherever it will remain fixed.
Do not lift the grille any further when it stops with a clicking sound.
2. Push the TEMPORARY button to start the air conditioner.
Push this button once again to stop it.
About this details, see page 23.
TEMPORARY button
NAMES AND FUNCTIONS OF INDICATORS AND CONTROLS
ON INDOOR UNIT
1 2 3
In case of timer setting by wired remote controller,
lamp does not light.
In case of twin and group combination,
lamp goes on main unit only. (
see page 7.)
NOTES
When the power is turned on for the first time after installation,
lamp lights up for approximately 5 minutes for
setting of addresses of systems and units. When the power is turned on the next time,
lamp lights up for
approximately 1 minute.
While the above lamp is on, all the commands from the remote control cannot be received. However, this is not a
malfunction or failure.
CAUTION
6 5
8 9 7
UNIT
SET
CL
SETTING
UNIT No.
CODE No.
TEST
SET DATA
R.C.
No.
2
!
4
1
3
"
01(EN)_1075000646 P03-07
7/16/04, 13:33
3
3