Toshiba RAV-SM1103AT-E1, Service Manual, Page: 78 / 93

– 78 –
1
Push
SET
+
CL
+
TEST
buttons simultaneously
for 4 seconds or more.
2
(
← ←
← ← ←
Line address)
Using the temperature setup / buttons,
set 12 12 12 12 12 to the CODE No.
3
Using timer time / buttons, set the line address.
4
Push
SET
button. (OK when display goes on.)
5
(
← ←
← ←
←
Indoor unit address)
Using the temperature setup / buttons, set
13 13
13 13 13 to the CODE No.
6
Using timer time / buttons, set 1 to the line address.
7
Push
SET
button. (OK when display goes on.)
8
(
← ← ← ← ←
Group address)
Using the temperature setup / buttons, set 14 14 14 14 14 to the CODE No.
9
Using timer time / buttons, set 0000 0000 0000 0000 0000 to Individual, 0001 0001 0001 0001 0001 to Master unit, and 0002 0002 0002 0002 0002 to sub unit.
10
Push
SET
button. (OK when display goes on.)
11
Push
TEST
button.
Setup completes. (The status returns to the usual stop status.)
10-5. Confirmation of Indoor Unit No. Position
1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
Push
ON / OFF
button if the unit stops.
2
Push UNIT LOUVER button.
Unit No. 1-1 1-1
1-1 1-1
1-1 is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
UNIT LOUVER
button.