Toshiba RAV-GP561ATW-E, Service Manual, Page: 122 / 131

122
(8) PMV coil 1. Detachment
1) Following to work of Detachment of (4).
2) Cut the cable-tie (two positions) on the back surface
3) Pull the connector for PMV coil out of control P.C.
board.
(Remove the clamp filter installed to near the
connector to attach it to the coil lead wires
replaced.)
4) Remove the coil from the PMV body by rotating the
coil (about 45°) while drawing the coil upward.
2. Attachment
Attach the PMV coil in the reverse process of
“
1. Detachment ”
1) Fix the coil positioning protrusions securely in the
concavities of the PMV body.
(Fix the coil in the direction where lead wire comes
out at the body’s left diagonally behind.)
2) Attach the PMV coil connector to the control P.C.
board.
(Wind the connector wire to the clamp filter once
and attach the clamp filter to near the connector.)
(9) 4-way valve coil 1. Detachment
1) Following to work of Detachment of (5), 1) to 5).
2) Cut the cable-tie A5 bundling up
4-way valve coil lead wires, TD sensor lead wires,
Compressor lead wires, Compressor case
thermostat lead wires and Fan motor lead wires.
3) Cut the cable-tie A6 fixing the clamp filter.
4) Remove the 4-way valve coil.
(M5 screw)
2. Attachment
Attach the 4-way valve coil in the reverse process of
“
1 Detachment ”.
*1 Fix the 4-way coil with its lead wires upward.
*2 Fix the clamp filter around the 4-way valve coil
through a commercially available cable-tie into the
hole for fixing cable-tie of clamp filter. (Example 1
(Page 116))
No. Part name Procedure Remarks
PMV coil connector
PMV coil
Clamp filter
(Example 2 (Page 116))
Bundle the all lead wires on
the back face and then cut the
cable-tie fixing inverter box. Bundle the all lead wires on
the back face and then cut the
cable-tie fixing inverter box. Bundle the all lead wires on
the back face and then cut the
cable-tie fixing inverter box.
Cut the cable-tie bundling up
TE sensor Black,
TL sensor Blue,
TS sensor Gray,
Pressure switch (Black tube),
Reactor lead wires White,
PMV coil lead wires. Cut the cable-tie bundling up
TE sensor Black,
TL sensor Blue,
TS sensor Gray,
Pressure switch (Black tube),
Reactor lead wires White,
PMV coil lead wires. Cut the cable-tie bundling up
TE sensor Black,
TL sensor Blue,
TS sensor Gray,
Pressure switch (Black tube),
Reactor lead wires White,
PMV coil lead wires.
PMV coil connector PMV coil connector PMV coil connector
4-way
valve coil
connector 4-way
valve coil
connector 4-way
valve coil
connector
Cable-tie A1 Cable-tie A1 Cable-tie A1
Cable-tie A2 Cable-tie A2 Cable-tie A2
Cable-tie A5 Cable-tie A5 Cable-tie A5
Cable-tie A5
Clamp filter
one time pass
4-way valve
coil lead wires
(Upper side) 4-way valve
coil lead wires
(Upper side) 4-way valve
coil lead wires
(Upper side)
Cable-tie A6 Cable-tie A6 Cable-tie A6