Toshiba MMY-MAP0804FT7(Z), Service Manual, Page: 185 / 333

– 185 –
Check code
Location
of
detection
System status Description
Error detection
condition(s)
Check items (locations)
Outdoor 7-segment display Main
remote
controller
Check
code
Sub-code
I/F Detected
outdoor unit No.
Display of center
unit only
H07 H07
All stop Operating compressor detects
continuous state of low oil level
for about 2 hours. <All outdoor units in
corresponding line to be
checked>
• Check balance pipe service
valve to confirm full opening.
• Check connection and
installation of TK1, TK2, TK3,
TK4, and TK5 sensors.
• Check resistance
characteristics of TK1, TK2,
TK3, TK4, and TK5 sensors.
• Check for gas or oil leak in
same line.
• Check for refrigerant
entrapment inside compressor
casing and check for liquid
back.
• Check SV3A, SV3B, SV3C,
SV3D, SV3E, and SV3F
valves for defect.
• Check oil return circuit of oil
separator for clogging.
• Check oil equalizing circuit for
clogging.
• Check SV6 circuit leakage. Low oil level
protection
I/F 01: TK1 sensor
error
02: TK2 sensor
error
03: TK3 sensor
error
04: TK4 sensor
error
05: TK5 sensor
error
H08 H08
H15 — H15
All stop Sensor resistance is infinity
or zero (open/short circuit). • Check connection of TK1
sensor connector.
• Check resistance
characteristics of TK1 sensor.
• Check for defect in outdoor
P.C. board (I/F). Error in
temperature
sensor for oil level
detection
I/F All stop Discharge temperature of (TD2)
does not increase despite
compressor 2 being in
operation. • Check installation of TD2,
TK1, TK2, TK3 sensor.
• Check connection of TD2,
TK4, TK5 sensor connector
and wiring.
• Check resistance
characteristics of TD2 sensor.
• Check for defect in outdoor
P.C. board (I/F). TD2 sensor
miswiring
(incomplete
insertion)
All stop Sensor resistance is infinity
or zero (open/short circuit). • Check connection of TK2
sensor connector.
• Check resistance
characteristics of TK2 sensor.
• Check for defect in outdoor
P.C. board (I/F).
All stop Sensor resistance is infinity
or zero (open/short circuit). • Check connection of TK3
sensor connector.
• Check resistance
characteristics of TK3 sensor.
• Check for defect in outdoor
P.C. board (I/F).
All stop Sensor resistance is infinity
or zero (open/short circuit). • Check connection of TK4
sensor connector.
• Check resistance
characteristics of TK4 sensor.
• Check for defect in outdoor
P.C. board (I/F).
All stop Sensor resistance is infinity
or zero (open/short circuit). • Check connection of TK5
sensor connector.
• Check resistance
characteristics of TK5 sensor.
• Check for defect in outdoor
P.C. board (I/F).
AMP Air Conditioning www.ampair.co.uk | sales@ampair.co.uk