Toshiba IK-WR01A, Operation Manual

Page: 14 / 94

14
Installation/Set up
V
iewing
and Operation
Recording
Setting up
Others
Connecting to a Video Monitor
Connecting to a Video Monitor
You can view camera images on the video monitor.
Important
●
Power plugs of connected equipment must be disconnected before installation.
●
A 75-ohm coaxial cable (3C-2V or 5C-2V) is required for standard connection.
●
For details of wiring and operation of equipment to be connected, refer to their
operation manuals.
●
Coaxial cables for video signals, LAN cable and the power cord are not supplied with
the camera.
●
Do not connect AC24V and DC12V at the same time. It may cause a malfunction of
the camera or AC adapter.
●
Use a 4 pair twisted cable for the LAN cable to connect the camera to a PoE
compatible hub.
●
Use IEEE802.3af-compliant PoE devices.
●
An AC adapter is not supplied with the network camera. When using an AC adapter,
a 10 watt or greater AC adapter is required.
●
The camera takes about 30 seconds to start after the power is turned on.
Rear
AC24V or DC12V
•
On the power supply, use a PoE compatible hub, or connect
AC24V or DC12V power plug.
PoE
LAN cable
Either
Video Monitor
24V AC UL Listed Class 2 power supply / 12V DC power supply
CAUTION : Never input AC/DC and PoE at the same time. It may cause a
malfunction of the camera. Ensure that the PoE/POWER SELECT
switch is properly set before inputting power.
In case of DC12V, connect “+12” to red cable and “GND” to black cable.
Do not overload power supply
Since this camera uses 24V AC UL Listed Class 2 power supply or 12V DC power
supply, it should be connected to a power supply that allows for at least 5w
consumption. Because the IK-WR01A uses a mechanism, a sufficient power supply
with adequate current specifications is required.