Toshiba GX7R ASD, Quick Start Manual, Page: 69 / 85

GX7R ASD Quick Start Guide 61
Note: The event that caused the Trip(s) must be corrected or must decrease to less than the threshold
value required to cause the trip to allow for a Reset to be recognized. In the event of multiple
active trips, the trip displayed will remain until all faults are corrected and all trips are cleared.
Dynamic Braking Resistor Overcurrent • Unsupported DBR configuration attempt.
• ASD inability to discharge the bus voltage during regeneration.
• No dynamic braking resistor (DBR) installed.
• Deceleration time is too short.
• Improper DBR setup information.
• Defective IGBT7 (or IGBT7 circuit).
• 3-phase input voltage is above specification.
Dynamic Braking Resistor Overload • Unsupported DBR configuration attempt.
• Deceleration time is too short.
• DBR setting adjustment required.
• Overvoltage Stall setting adjustment required.
Earth Fault • Ground fault at the motor.
• Ground fault at the output of the ASD.
• Current leakage to Earth Ground .
EEPROM Data Fault • EEPROM read malfunction.
EEPROM Fault • EEPROM write malfunction.
Emergency Off • Emergency Off command received via EOI or remotely.
Encoder Loss • Encoder signal missing while running during closed-loop operation.
Flash Memory Fault • Flash memory malfunction.
Gate Array Fault • Defective Gate Array or Gate Array malfunction.
Input Phase Loss • 3-phase input to the ASD is low or missing.
Load Drooping • Load requirement is in excess of the capabilities of the motor.
Load End Short Circuit • Improper wiring at the ASD output to the motor.
Low Current • Improper Low Current detection level setting.
Main Board EEPROM Fault • Internal EEPROM malfunction.
Motor Overload • V/f setting needs to be adjusted.
• Motor is locked.
• Continuous operation at low speed.
• Load requirement exceeds ability of the motor.
• Startup frequency setting adjustment required.
No Fault • No active faults.
Option Fault • Optional device malfunction.
• Improper system settings (at ASD or optional device).
• Loose or improper connection.
Fault Screen Display Possible Causes