Toshiba GX7R ASD, Quick Start Manual, Page: 27 / 85

GX7R ASD Quick Start Guide 19
this output terminal are listed in the GX7R ASD Install and Op Manual . For further information on this
terminal, see F670 .
FM — This output terminal produces an output current that is proportional to the output frequency of
the ASD or of the magnitude of the function assigned to this terminal. The available assignments for
this output terminal are listed in the
GX7R ASD Install and Op Manual . For further information on this
terminal, see F005 .
FLA
— One of two normally open contacts of a form C relay that, under user-defined conditions,
connect to FLC. The FL relay is the Fault Relay by default, but may be programmed to any of the
selections of the
GX7R ASD Install and Op Manual and may be set as Normally Open or Normally
Closed . For further information on this terminal, see F132 and Figure 4.
FLB — One of two normally closed contacts of a form C relay that, under user-defined conditions,
connect to FLC .
FLC
— FLC is the common leg of a single-pole double-throw form C relay.
Note: The FLA , FLB , and FLC contacts are rated at 2A/120 VAC and 2A/30 VDC.
Figure 4. FLA, FLB, and FLC Switching Contacts Shown in the Normal Operating Condition.
Note: The relay is shown in the normal operating condition. During
a faulted condition, the relay connection is FLC -to- FLA .