Toshiba GX7R ASD, Quick Start Manual

Page: 68 / 85

60 GX7R ASD Quick Start Guide
Trips/Faults
A Trip is an ASD response to a Fault (though, Fault and Trip are sometimes used interchangeably). A
Trip is a safety feature that disables the ASD system in the event that a subsystem of the ASD is
experiencing an overload condition or a malfunction.
Listed in Table 11 are the possible Faults that may cause a Trip and the possible causes. When a Trip is
incurred the system displays the Fault screen. The Fault screen identifies the active Fault .
Table 11. GX7R ASD Faults.
Fault Screen Display Possible Causes
Note: The event that caused the Trip(s) must be corrected or must decrease to less than the threshold
value required to cause the trip to allow for a Reset to be recognized. In the event of multiple
active trips, the trip displayed will remain until all faults are corrected and all trips are cleared.
ASD Overload • Acceleration time is too short.
• DC Injection current is too high.
• V/f setting needs to be adjusted.
• Motor running during restart.
• ASD or the motor is improperly matched to the application.
Autotune Error • Autotune readings that are significantly inconsistent with the configuration
information.
• A non-3-phase motor is being used.
• Incorrect settings at F400 , F413 , or F414 .
• Using a motor that has a significantly smaller rating than the ASD.
• ASD output cabling is too small, too long, or is being housed in a cable tray with
other cables that are producing an interfering EMF.
• Motor is running during the Autotune function.
Communication Error • Communication malfunction.
• Improper or loose connection.
• Improper system settings.
Control Power Undervoltage • This fault is caused by an undervoltage condition at the 5, 15, or the 24 VDC
supply.
• 3-phase input voltage low.
CPU Fault • CPU malfunction.
MOFF • 3-phase input voltage low.
• Defective control board.
• Excessive load on the power supply.
• Undervoltage/Ridethrough settings require adjustment.
DC Fuse Open • Internal DC bus fuse is open.
• Confirm at Fuse Open LED at the Gate Driver Board.