Toshiba GX7R ASD, Quick Start Manual

Page: 37 / 85

GX7R ASD Quick Start Guide 29
GX7R ASD EOI and Front Panel Features
The GX7R ASD Electronic Operator Interface (EOI) is comprised of an LCD display, two LEDs, a
rotary encoder, and eight keys. These items are described below and their locations are provided in Figure
19 on pg. 30 .
The EOI may be mounted remotely using the optional ASD-MTG-KIT . Or if operating in a NEMA 4
environment, the ASD-EOI-N4 is best suited for this application. Each kit contains all of the hardware
required to mount the EOI of the ASD remotely.
The EOI can be mounted remotely from the ASD as described in the GX7R ASD Install and Op Manual .
The dimensional requirements for remote mounting may also be found in this section. Using a screw
length that exceeds the specified dimensions may cause deformation of the outer surface of the bezel and
should be avoided.
The interface can operate up to distances of 15 feet from the ASD via the Common Serial (TTL) Port. For
distances beyond 15 feet, the RS232/RS485 port is recommended.
EOI Features
LCD Display — Displays configuration information, performance data (e.g., motor frequency, bus
voltage, torque, etc.), and diagnostic information.
Enter Key — Selects a menu item to be changed or accepts and records the changed data of the selected
field (same as pressing the Rotary Encoder ).
Up Key — Increases the value of the selected numerical parameter or scrolls up the menu listing
(continues during press-and-hold).
Down Key
— Decreases the value of the selected numerical parameter or scrolls down the menu listing
(continues during press-and-hold).
Rotary Encoder — Functions as the Up key, the Down key, and the Enter key. Turn the Rotary
Encoder either clockwise or counterclockwise to perform the Up or Down key functions. Press the
Rotary Encoder to perform the Enter function. Simultaneously press and turn the Rotary Encoder to
perform a user-defined function (see Program

EOI Option Setups

Preferences

Encoder Action ).
ESC Key — Returns to the previous level of the menu tree, toggles between the Panel Menu and the
Frequency Command screens, or cancels changes made to a field if pressed while still in the reverse video
mode (dark background/light text). The three functions are menu-specific.
Stop Key — While running, issues the Off command (decelerates to Stop at the programmed rate) if
pressed once while in the Local mode or initiates an Emergency Off (terminates the ASD output and
applies the brake if so configured) if pressed twice quickly from the Local or Remote modes. Resets the
ASD if pressed twice quickly while stopped.
Local|Remote Key — Toggles the system to and from the Local and Remote modes. The LED is on
when the system is in the Local Command mode. The Local mode allows the Command and Frequency
control functions to be carried out via the EOI.
The Remote mode enables the Command and Frequency control functions to be carried out via the
Terminal Board , CN8 Option (Not Used), RS232/RS485 , Communication Card , or Pulse Input . The
selection may be made via Program

Fundamentals

Standard Mode Settings

Command Mode .
The availability of the Local mode of operation ( Command and Frequency control) may be disabled via
Program

EOI Option Setups

Local|Remote Key . The availability of the Local mode of operation
may be reinstated by changing this setting or performing a Reset (see F007 ).
ocal|Remote
Key