Toshiba GD-1151, Operator'S Manual

Page: 31 / 190

29
2
4. Setting the Transmission Conditions
Variety of optional functions
Originals can be sent using different transmission conditions (resolution, original mode, exposure, trans-
mission mode, original size, ECM, quality TX, Line, SUB/SEP, SID/PWD, subject and body). Settings for
the subject and body are available only when you are using the Internet Fax function. If you change the
transmission conditions, the new settings are valid for one transmission only. They return to the default
settings after the transmission. The following describes the settings of each item.
• Resolution:
Set the resolution before you scan the original to be sent.
STANDARD: Original with regular size text
FINE:
Original with small size text and fine illustrations
U-FINE: Original with ultra-fine illustrations
* If the remote Fax cannot receive originals with the same resolution, the resolution of the sent
original is automatically converted and sent.
The finer the resolution is, the longer it takes to send an original.
• Original Mode:
Set the original mode before you scan the original to be sent.
TEXT, TEXT/PHOTO, PHOTO
*
Transmission time may be longer than usual when the TEXT/PHOTO mode or PHOTO mode is
selected.
• Exposure:
Set the image density according to the contrast of the original to be sent.
AUTO, MANUAL (11 variations)
*
In the automatic exposure mode, the equipment automatically judges the contrast of the origi-
nal, and selects the ideal contrast.
In the manual exposure mode, you can adjust the contrast manually with 11 variations.
• Transmission Type:
Set the transmission type.
MEMORY TX: Send the original after it is scanned into memory.
DIRECT TX: Send the original directly as it is being scanned.
• Original Size:
Set the scan size of the original to be sent.
AUTO:
The size of the original is automatically determined before it is scanned.
SPECIFIED SIZE:
The original is scanned at the preset size regardless of its actual size.
Use this mode when you are using non-standard size paper or you want to limit the area of the
original to be sent.
DIFFERENT WIDTH:
Set this function to send the originals with different width at a time using Reversing Automatic
Document Feeder (optional). (
P.33 “Sending different width originals”)
• ECM (Error Correction Mode):
ECM (Error Correction Mode) is an internationally standardized communication mode that automati-
cally corrects errors that occur during Fax transmissions. Even when the transmitted data has been
affected by noise during communication, this mode allows good communication without image distor-
tion by automatically resending the part that has been affected.
ON, OFF
*
Both the transmitter and the receiver must have the ECM function to make ECM communica-
tion available. When affected by noise during communication, communication time takes longer
than usual.