Toshiba GA-1191, Setup Manual

Page: 90 / 156

10 TopAccess ADMINISTRATION TAB PAGE - SETUP
MENU (Printing Function)
88 Setting up Network Settings (Printing Function)
Setting up the TCP/IP
You can set the TCP/IP protocol to enable communication over TCP/IP. The TCP/IP must be
configured to enable TopAccess, Raw TCP or LPR printing, and IPP printing.
1) Address Mode
Select how to set the IP address.
- Static IP — Select this to assign the static IP address manually. When this is selected,
enter the static IP address in the IP Address field.
- No AutoIP — Select this to assign the IP address using the DHCP with Auto-IP address-
ing disabled. When this is selected, the IP address, subnet mask and default gateway
can be automatically obtained from the DHCP server if the network supports the DHCP,
but the IP address will not be assigned if the network does not support the DHCP.
- Dynamic — Select this to assign the IP address using the DHCP with Auto-IP address-
ing enabled. When this is selected, the IP address, subnet mask and default gateway
can be automatically obtained from the DHCP server if the network supports the DHCP,
and the IP address can be also assigned using Auto-IP addressing even if the network
does not support the DHCP.
2) IP Address
Enter the static IP address that is assigned to this equipment when “Static IP” is selected in
the “Address Mode” drop down box.
3) Subnet mask
Enter the subnet mask if required when “Static IP” is selected in the “Address Mode” drop
down box.
4) Default Gateway
Enter the gateway address if required when “Static IP” is selected in the “Address Mode”
drop down box.
5) IP Filtering
When you want to set the IP filtering, specify the range of IP addresses in the Start Address
and End Address fields.
When you specify the range of IP addresses, only the client that the specified IP address
range is assigned can access the equipment.
1
2
3
4
5