Toshiba e-studio281c, Service Handbook, Page: 486 / 678

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 80
[CC80] Front jogging motor abnormality/Front aligning plate motor abnormality
[CC80] Rear alignment motor abnormality
MJ-1022 (Front jogging motor abnormality)
Is the front jogging plate home position sensor (S6) working properly?
È NO Æ Replace the sensor.
YES
Is the wiring between the finisher controller PC board and front jogging motor (M3) correct?
È NO Æ Correct the wiring.
YES
Has the rack run over the stopper of the roll?
È YES Æ Fix it.
NO
1) Replace the front jogging motor.
2) Replace the finisher controller PC board.
MJ-1023/1024 (Front aligning plate motor abnormality)
Is the front aligning plate home position sensor (PI36) normal?
È NO Æ Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the front aligning plate motor (M33)
correct?
È NO Æ Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
È NO Æ Fix the mechanism.
YES
1) Replace the front aligning plate motor.
2) Replace the finisher controller PC board.
* You receive a [CC80] error when the [ED14] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the rear alignment plate is moved?
È
Æ YES Fix the mechanism.
NO
Is the harness between the rear alignment motor (M10) and the finisher control PC board
(CN10) disconnected or open circuited?
l
È
Æ YES • Reconnect the connector securely.
• Replace the harness.
NO
1) Replace the rear alignment motor (M10).
2) Replace the finisher control PC board.
06/08