Toshiba e-studio281c, Service Handbook, Page: 483 / 678

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
TROUBLESHOOTING
5 - 77
5
[CC41] Paper holder cam home position abnormality
[CC50] Horizontal registration motor abnormality
[CC51] Sideways adjustment motor (M2) abnormality
MJ-1101
Is there any mechanical problem when the paper holder cam is rotated?
È
Æ YES Fix the mechanism.
NO
Is the harness between the paper holder home position sensor (S6) and the finisher control PC
board (CN17) disconnected or open circuited?
l
È
Æ YES • Reconnect the connector securely.
• Replace the harness.
NO
1) Replace the paper holder home position sensor (S6).
2) Replace the finisher control PC board.
MJ-1023/1024 (when MJ-6004 is installed)
Is the horizontal registration home position sensor (PI61) working normally?
È NO Æ Replace the sensor.
YES
Is the wiring between the horizontal registration home position sensor and finisher controller
PC board correct?
È NO Æ Correct the wiring.
YES
Is the horizontal registration mechanism normal?
È NO Æ Fix the mechanism.
YES
1) Replace the horizontal registration motor (M62).
2) Replace the punch controller PC board.
3) Replace the finisher controller PC board.
* The [CC51] error will be displays when the [ED11] error occurs three times in succession or
during the initial operation.
MJ-1101 (When MJ-6101 is installed)
Is there any paper remaining on the transport path?
È
Æ YES Remove the paper.
NO
Rotate the sideways adjustment motor (M2). Does it rotate smoothly?
È
Æ NO Fix the mechanism.
YES
Are the sideways deviation home position sensor (S3) and its wiring correct?
È
Æ NO Replace the sensor. Correct the wiring.
YES
Is the wiring between the hole punch control PC board (HP) and sideways adjustment motor
(M2) correct?
È
Æ NO Correct the wiring.
YES
1) Replace the punch sideways adjustment motor (M2).
2) Replace the hole punch control PC board (HP).
06/08