Toshiba e-studio281c, Service Handbook, Page: 279 / 678

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
ADJUSTMENT
3 - 13
3
[G-2] Adjustment for short-sized paper
(1) While pressing [0] and [5] simultaneously, turn the power ON.
→
(Adjustment Mode)
(2) Press [3]
→
[FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from the upper
drawer.)
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
<Procedure>
(Adjustment Mode)
→
(Key in the code [498])
→
[START]
→
[1]
→
[START]
→
(Key in a value (acceptable values: 0 to 255))
→
[ENTER] or [INTERRUPT] (Stored in memory)
→
"100% A" is displayed
→
Press [3]
→
[FAX]
→
(A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.04 mm/
step).
<Adjustment procedure summarization for A to E>
[0] [5] [Power ON]
→
[1] ([3](05-445, 498) for duplexing)
→
[FAX]
A: 05-401 (Lower drawer, A3/LD) → 200±0.5 mm (0.1 mm/step)
B: 05-411 (Lower drawer, A3/LD) → 52±0.5 mm (0.04 mm/step)
→
Key in the same value for 05-410.
C: 05-421 (Lower drawer, A3/LD)
→
200±0.5 mm (0.5 mm/6 steps)
D: 05-440 (Upper drawer, A4/LT) → 52±0.5 mm (0.2 mm/step)
441 (Lower drawer, A3/LD),
442 (Bypass feed, A4/LT),
443 (LCF, A4/LT), 444 (PFP, A4/LT),
445 (Duplexing, A3/LD)
E: 05-498-0 (Lower drawer, A3/LD), → 52±0.5 mm (0.04 mm/step)
498-1 (Upper drawer, A4/LT)