Toshiba e-studio281c, Service Handbook, Page: 27 / 678

© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 5
2
E910 Finisher jam
(Bridge unit)
Jam at the bridge unit transport sensor 1: The
paper does not reach the bridge unit transport sen-
sor 1 after it has passed the exit sensor.
P. 5-29
E920 Stop jam at the bridge unit transport sensor 1: The
trailing edge of the paper does not pass the bridge
unit transport sensor 1 after its leading edge has
reached the sensor.
P. 5-29
E930 Jam at the bridge unit transport sensor 2: The trail-
ing edge of the paper does not reach the bridge unit
transport sensor 2 after its leading edge has
reached the bridge unit transport sensor 1.
P. 5-29
E940 Stop jam at the bridge unit transport sensor 2: The
trailing edge of the paper does not pass the bridge
unit transport sensor 2 after its leading edge has
reached the bridge unit transport sensor 2.
P. 5-29
E9F0 Finisher jam
(Punch unit)
Punching jam: Punching is not performed properly.
[MJ-1023/1024 (when MJ-6004 is installed)]
[MJ-1101 (when MJ-6101 is installed)]
P. 5-46
EA10 Finisher jam
(Finisher section)
Paper transport delay jam: The paper which has
passed the bridge
unit does not reach the inlet sensor. [MJ-1022/
1023/1024/1101]
P. 5-30
EA20 Paper transport stop jam:
(1) The paper does not pass through the inlet sen-
sor.
[MJ-1022/1023/1024]
(2) The paper has passed through the inlet sensor
but does not reach or pass the feed path sensor
or processing tray sensor.
[MJ-1023/1024]
(3) The paper which has passed through the inlet
sensor does not reach the transport sensor.
[MJ-1101]
P. 5-32
EA21 Paper size error jam: Paper does not reach the sen-
sor because the paper is shorter than spec. [MJ-
1101]
P. 5-33
EA30 Power-ON jam:
(1) Paper exists at the inlet sensor when power is
turned ON.
[MJ-1022/1023/1024]
(2) Paper exists at the feed path sensor or pro-
cessing tray sensor when power is turned ON.
[MJ-1023/1024]
P. 5-34
EA31 Transport path paper remaining jam: The paper
which has passed through the inlet sensor does not
reach the transport sensor. [MJ-1101]
P. 5-35
EA32 Exit paper remaining jam: The paper is remaining
on the finishing tray when the power is turned ON.
[MJ-1101]
P. 5-35
Error code Classification Contents Troubleshooting
06/08