![background image](http://html.mh-extra.com/html/toshiba/e-studio222cp/e-studio222cp_user-manual_429095035.webp)
Menu functions > 35
USB
MENU
This menu controls the operation of the printer’s USB data interface.
N
ETWORK
MENU
This menu controls the operation of the printer’s 10Base-T/100Base-TX network interface.
ITEM
SETTINGS
EXPLANATION
SOFT RESET
ENABLE / DISABLE
Enables or disables the SOFT RESET command.
SPEED
12Mbps / 480Mbps
Selects the interface speed.
OFFLINE RECEIVE
ENABLE / DISABLE
Enables or disables this function. When set to Enable,
the interface retains a receive possible state even when
switching to Offline. Interface sends the BUSY signal
only when the receive buffer is full or a service call
occurs.
SERIAL NUMBER
ENABLE / DISABLE
Specifies whether to ENABLE or DISABLE a USB serial
number.
The USB serial number is used to identify the USB
device connected to your PC.
NOTE
When you have changed any settings in the USB MENU, turn the printer OFF,
then ON again.
ITEM
SETTINGS
EXPLANATION
TCP/IP
ENABLE / DISABLE
Enables or disables this network protocol.
IP VERSION
IP v4
IP v4+v6
IP v6
Sets up the IP version.
Operates with IPv4 only (not valid with IPv6).
Operates with both IPv4 and IPv6.
Operates with IPv6 only (not valid with IPv4).
From this stage, if IPv6 only is set from UI, for example
Telnet, “IP v6” appears as the value of IP Version on
the operation panel. “IP v6” will disappear from the
value if “IP v4” or “IP v4+v6” is selected.
Display Condition: TCP/IP should be enabled.
NETBEUI
ENABLE / DISABLE
Enables or disables this network protocol.
NETBIOS OVER TCP
e-STUDIO222CP:
ENABLE / DISABLE
e-STUDIO262CP:
ENABLE / DISABLE
Sets Enable/Disable of NetBIOS over TCP protocol.
Display Conditions:
>
> TCP/IP should be enabled.
>
> IP Version is not IPv6.
NETWARE
e-STUDIO222CP:
ENABLE / DISABLE
e-STUDIO262CP:
ENABLE / DISABLE
Enables or disables this network protocol.
ETHERTALK
ENABLE / DISABLE
Enables or disables this network protocol.
FRAME TYPE
AUTO / 802.2 / 802.3 /
ETHERNET II / SNAP
Selects the Ethernet MAC layer frame type.
Display Condition: Netware should be enabled.
IP ADDRESS SET
AUTO / MANUAL
Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.