5
© 2015 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SELF-DIAGNOSTIC MODE
5 - 1
5.
SELF-DIAGNOSTIC MODE
5.1
Overview
This equipment consists of two servicing menus whose start-up method differs. Setting and adjustment
can be performed by entering into a mode such as [05 ADJUSTMENT MODE] or [49 Firmware update
mode] from each menu.
•
FS Menu
•
HS Menu
*
Only the modes which are available for this equipment are displayed on each menu.
Mode
Contents
03 TEST MODE
Checks the status of input/output signals.
04 TEST PRINT MODE
Outputs the test patterns.
05 ADJUSTMENT MODE
Adjusts various items.
08 SETTING MODE
Sets various items.
20 PM SUPPORT MODE
Clears each counter.
21 EPU REPLACE MODE
When replacing EPU, this mode is available for the
installation of the EPU whose initial detection is possible.
30 LIST PRINT MODE
Prints various lists or outputs them in a CSV format.
31 CHART PRINT MODE
Prints the charts.
FAX
11 FAX CLEAR MODE
Sets the fax board.
12 FAX LIST PRINT MODE
Outputs the contents set for the fax functions.
13 FAX FUNCTION MODE
Sets the fax functions.
19 RAM EDIT MODE
This is the mode for the special settings. (This is not used
generally.)
Mode
Contents
01 Control panel check mode
Checks various contents regarding the LCD, LED, hard
keys and digital keys on the control panel.
49 Firmware update mode
Performs firmware update with a USB storage device.
59 SRAM data cloning mode
Backs up the SRAM data to a USB storage device.
73 Assist mode
Clears error flags or SRAM, or safely deletes data in the
HDD or SRAM to support the replacement of the SYS
board, SRAM or HDD.
74 HDD assist mode
Assists the ADI-HDD by checking the type of the mounted
HDD, reverting the HDD to a factory default or removing
keys.
75 File system recovery mode
Checks, recovers or initializes the file system (HDD).
76 SRAM clear mode
Recovers the equipment from particular errors such as
F800 or F900.