6
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
SETTING / ADJUSTMENT
6 - 45
6.10.3
Adjustment of the leading edge position
Notes:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF.
[A] Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Simplex copy
(1) Place the chart on the RADF original tray with the image face up.
(2) Select [1
1 SIMPLEX] and press the [START] button.
(3) Place the copy on top of the chart, and check the displacement of the margin of the copied
image.
Duplex copy
(1) Place the chart on the RADF original tray with the image face down (Fig.6-34).
(2) Select [2
2 DUPLEX] and press the [START] button.
Fig.6-34