e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 46
4.6.16
Registration sensor (S2)
(1) Open the right cover.
(2) Take off the duct unit.
(3) Take off the registration roller (metal).
P. 4-44 "4.6.14 Registration roller (metal)"
(4) Remove one screw and then slide the
registration guide [1] towards the rear and
remove it.
Fig. 4-118
Notes:
When installing the registration guide, insert
the latch at the rear side into the damp
heater bracket [2], slide it to the front side,
and then insert the two bosses into the damp
heater bracket.
Fig. 4-119
(5) Remove the actuator [3] and the springs [4]
and then release the 3 latches to remove the
registration sensor [5].
(6) Disconnect 1 connector [6].
Fig. 4-120
[1]
[2]
[5]
[6]
[3]
[4]
