Toshiba e-studio1105, Operating Instructions Manual, Page: 180 / 396

IPv6 access mask configuration
msh> access ID mask6 "base-address prefixlen"
Example: to specify accessible IPv6 addresses to 2001:DB8::/32
msh> access 1 mask6 2001:DB8:: 32
Access control initialization
msh> access flush
• Use the "flush" command to restore the default settings so that all access ranges become "0.0.0.0"
for IPv4, and "::" for IPv6.
• You can specify each IPv6 entry by either range or mask. For the range parameter, you can select
"start-address end-address". For the mask parameter, you can select "base-address prefixlen".
• The access range restricts computers from use of the machine by IP address. If you do not need to
restrict printing, make the setting "0.0.0.0" for IPv4, and "::" for IPv6.
• Valid ranges must be from lower (start address) to higher (end address).
• For IPv4 and IPv6, you can select an ID number between 1 and 5.
• IPv6 can register and select the range and the mask for each access ranges.
• IPv6 mask ranges between 1 - 128 can be selected.
• Up to five access ranges can be specified. The entry is invalid if the target number is omitted.
• You cannot send print jobs, or access Web Image Monitor and diprint from a restricted IP address.
appletalk
Use the "appletalk" command to view and configure AppleTalk parameters.
View settings
msh> appletalk
• [2] means "active" and [0] means "inactive".
• The default is [2].
Changing PAP timeout configuration
msh> appletalk ptimeout value > 0
• Timeout value becomes effective.
msh> appletalk ptimeout value = 0
• Timeout value becomes ineffective.
5. Monitoring and Configuring the Printer
178
5