Toshiba e-studio 5560c, Copying Manual, Page: 16 / 188

1 BEFORE USING EQUIPMENT
14 Placing Paper
y Up to 600 sheets (64 g/m
2
) (17 lb. Bond) can be placed in one drawer. Be sure that the height of the stacked
paper does not exceed the line indicated inside of the side guides.
P.11 “Acceptable copy paper”
y Tidy the paper and place it while aligning it with the right-hand inside surface of the drawer. If there is a gap,
paper misfeeding or size detection failure could result.
y Place paper with its copy side up. The copy side may be noted on its wrapping paper.
6
Fan and jog the stack of paper well.
y Fan and jog the stack of paper well before you place it in a
drawer, or the sheets may not be separated before being fed.
y Be careful not to cut your fingers when fanning.
7
Place paper in the drawer.
8
Move the end guide to the trailing edge of the paper
while pushing its lower part in the direction of the
arrows.
9
Confirm that there is no extra gap between the paper
and the side or end guides.
If the gap between the paper and the side or end guides is too big, this
equipment may not be able to detect the size of the paper, and this
would result in paper misfeeding.
Gap between the paper and the side guides (“A” in the figure on
the right): Do not make a gap of more than 0.5 mm (0.02") on one
side or 1.0 mm (0.04") on both sides. However, if a paper misfeed
occurs in the case of thick paper, create a suitable gap.
Gap between the paper and the end guide (“B” in the figure on the
right): Do not make a gap of more than 0.5 mm (0.02").
A
B