e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 144
4.7.6
Transfer belt unit (TBU)
Notes:
When replacing the transfer belt cleaner side
seals, follow the procedure below.
1. Move the blade to the rear side and then
install it with 2 screws.
2. Install the 2 transfer belt cleaner side
seals following the standard shown in the
figure.
3. After the side seals are attached, move
the bracket retaining the blade and check
that it is neither caught nor comes up on
to the side seal.
Fig. 4-420
Fig. 4-421
(1) Take off the transfer belt cleaning unit.
P. 4-141"4.7.3 Transfer belt cleaning unit"
(2) Pull out 2 hand grips.
Fig. 4-422
0~0.5 mm
0~0.5 mm
0~1 mm
0~1 mm
Blade
Side seal
Transfer belt cleaner side seal
Transfer belt cleaning blade
Rear side
Front side