Toshiba e-studio 2555c, Service Manual

Page: 484 / 1558

e-STUDIO2555C/3055C/3555C/4555C/5055C © 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 58
6.3.4 Adjustment of faint text
The faint text can be improved in the following codes.
<Adjustment Mode (05)>
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes to be adjusted and press the [START] button.
(3) Key in the adjustment value. (To correct the value once keyed in, press the [CLEAR] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value in memory.
→
The equipment goes
back to the ready state.
(5) For resetting the value, repeat step (2) to (4).
(6) Let the equipment restart and perform the printing job.
(7) If the desired image has not been attained, repeat step (1) to (6).
6.3.5 Upper limit value in the Toner Saving Mode
The upper limit value of the density when "Toner save" is selected in the Custom tab of the printer driver
can be adjusted.
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of

P. 6-54 "6.3.2 Gamma balance adjustment (Black Mode)".
Black mode Color mode
Remarks
PS PCL XPS PS PCL XPS
7340 7341 7342 8130 8131 8132 When the small characters or fine lines in a
halftone image are faint, they can be improved
by increasing the value to raise the density level.
Acceptable values: 0 to 8 (Default: 0)
Color PS PCL XPS 1200dpi Remarks
Black mode 7307-0 7307-1 7307-2 7302 The smaller the value is, the lighter
the density of image becomes.
Acceptable values: 0 to 255
(Default: 176)
Color mode 8160-0 81601- 8160-2 8161