Toshiba e-studio 2555c, Service Manual

Page: 376 / 1558

e-STUDIO2555C/3055C/3555C/4555C/5055C © 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 10
5.5 Test print mode (test mode 04)
<Procedure 1>
<Procedure 2>
Remarks:
In the (Color selection) of <Procedure 2>, the printing method is different between [K(1)] and
[K(4)] as follows.
•
[K(1)]: Printing by bringing one K color developer unit into contact with the transfer belt
• [K(4)]: The developer units of four (YMCK) colors are brought into contact with the transfer
belt, but the test pattern is printed in K color only.
* The number in parentheses indicates the contact of the developer unit and the transfer belt.
<Procedure 5>
Notes:
• When an error occurs, it is indicated on the panel, but the recovery operation is not performed.
Turn OFF the power and then back ON to clear the error.
• During test printing, the [CLEAR] button is disabled when “Wait adding toner” is displayed.
Refer to "15. SELF-DIAGNOSIS CODE (03/04/05/08 CODE)" in this manual for the codes available in
the test print mode.
The embedded test pattern can be printed out in the test print mode (04).
[0][4]
[POWER]
[POWER]
OFF/ON
(Exit)
(Code) (Media selection)
[START] [CLEAR] Operation
Continuous
Test Printing
[0][4]
[POWER]
[POWER]
OFF/ON
(Exit)
(Code) [START] [START]
[CLEAR]
[CLEAR]
Operation
Continuous
Test Printing
Color
selection
Media
selection
[0][4]
[POWER]
(Code) (Media
selection)
[START]
[POWER]
OFF/ON
(Exit)
[CLEAR] Operation
(Continuous
Test Print)
(Color
selection)
[Digital key]
[FUNCTION CLEAR]
（
Input density
）