Toshiba e-STUDIO 207L, Operation Manual

Page: 80 / 172

3 BASIC COPY MODES
78 Selecting Finishing Mode
5
Select the desired mode from [MAGAZINE SORT], [MAGAZINE SORT & CENTER
FOLD], [MAGAZINE SORT & SADDLE STITCH], [CENTER FOLD] or [SADDLE STITCH].
Then press [OK].

[MAGAZINE SORT & SADDLE STITCH] and [SADDLE STITCH] are selectable only when the
Saddle Stitch Finisher MJ-1108/MJ-1033 (optional) is installed.

[MAGAZINE SORT & CENTER FOLD] and [CENTER FOLD] are selectable only when the
Saddle Stitch Finisher MJ-1108 (optional) is installed.
6 Select other copy modes as required, and then press the [START] button on the control
panel.

Hole punch mode
You can punch copied paper when the Hole Punch Unit (optional) is installed on the Finisher.

Paper whose size is any of A3, A4, A4-R, B4, B5, B5-R, FOLIO, LD, LG, LT, LT-R, ST-R and COMP, and
whose weight is 64 to 209 g/m
2
(17 lb. Bond to 110 lb. Index) (MJ-6104) and 64 to 128 g/m
2
(17 to 34
lb. Bond) (MJ-6007/MJ-6008) is available.

Special paper such as OHP film or sticker labels is not applicable.
1
Place paper in the drawer(s).
When using bypass copying, be sure to set the paper size.
2
Place the original(s).
7 Combine the copied paper if the center fold mode or
magazine sort & center fold mode is used.
In the center fold mode, paper is folded at the center for every 5
sheets before exiting. If more than 5 sheets of paper are copied,
combine them as shown in the figure.
10~15
6~10
1~5
1~5 6~10 11~15