Automatic Hibernation Mode
The computer can be configured to enter Hibernation Mode automatically
when you press the power button. In order to define these settings, you can
follow the steps as described below:
1.
Click
Start
and click the
Control Panel
.
2.
Click
System and Security
and click
Power Options
.
3.
Click
Choose what the power buttons do
.
4.
Enable the desired Hibernation Mode settings for
When I press the
power button
.
5.
Click the
Save changes
button.
Data save in Hibernation Mode
When you turn off the power in Hibernation Mode, the computer will take a
moment to save the current data in memory to the hard disk drive.
After you turn off the computer, and the content of memory has been saved
to the hard disk drive, turn off the power to any peripheral devices.
Do not turn the computer or devices back on immediately. Wait a moment
to let all capacitors fully discharge.
Restarting the computer
Certain conditions require that you reset the computer, for example if:
You change certain system settings.
An error occurs and the computer does not respond to your keyboard
commands.
If you need to restart the computer, there are three ways this can be
achieved:
Click
Start
, point to the arrow icon (
) and then select
Restart
from the menu.
Press
CTRL
,
ALT
and
DEL
simultaneously (once) to display the menu
window, then select
Restart
from the
Shut down options
.
Press the power button and hold it down for five seconds. Once the
computer has turned itself off, wait between ten and fifteen seconds
before turning the power on again by pressing the power button.
User's Manual
1-11
Summary of Contents for DX 730
Page 1: ...User s Manual DX 730 ...
