124
Picture and Sound Controls
Adjusting the audio
3
Press the
p
/
q
(arrow) buttons to select
Auto
or
Manual
.
Auto:
This mode automatically adjusts the audio timing to meet
the video timing.
The time lag might be large between the image and sound
depending on the connected equipment (amplifier etc.). In
that case, select Manual.
Manual:
You can manually adjust the audio signal timing to meet
the video signal timing.
4
Press the
EXIT
button.
Delay Adjustment
1
Press the
SETUP
button.
2
Select
Sound
>
Digital Audio Output
>
Delay Adjustment
and
press the
OK
button.
3
Press the
t
/
u
(arrow) buttons to adjust the audio signal timing (0 –
250ms) to meet the video signal timing.
4
Press the
EXIT
button.
NOTE
v
This feature is grayed out when
Audio Delay
is in
Auto
.
v
A time lag will occur when the video signal or audio signal is changed.
Adjust the timing accordingly.
v
When adjusting the timing, turn down the volume of the AV equipment
used as far as possible.
Depending on the equipment, noise etc. may occur when the signal is
changed.
v
Depending on the connected equipment (amplifier, etc.), adjustment
may not be possible.
v
When the optical audio output setting (
Auto
t
PCM
) is changed, it
may be necessary to adjust the timing again.
v
Do not use other than for audio output from the AV amplifier, etc.
(Malfunction may occur)
Using the Dolby
®
Digital Dynamic Range Control feature
You can further compress Dolby
®
Digital and Dolby
®
Digital Plus
dynamic range so you can switch from digital to analog broadcasts at the
same dynamic range.
1
Press the
SETUP
button.
2
Select
Sound
>
Dynamic Range Control
and press the
OK
button.
3
Press the
p
/
q
(arrow) buttons to select
On
.