Part I: Getting to Know Your Computer
Learning the Basics
Turning off the computer
89
5
Click Override all Modes with settings here.
6
In the Set to range dialog box, do one of the following:
Click DC only for the settings to apply only when
you are using battery power.
Click All for the settings to apply whether you are
using battery power or outlet power.
7
Click OK.
8
Click OK again, then close the Control Panel.
NOTE: For more information about the Power Saver utility,
see
Starting again from Standby
To start the computer from Standby mode, press the power
button until the on/off light changes to green. The computer
returns to the screen you were using.
If you put the computer in Standby mode by closing the
display panel, you can start again by opening the display
panel.
Using Hibernation mode
To power down the computer using the Hibernation option,
click Start, Shut Down, select Hibernate, then click OK.
The computer saves the state of the system, including all
open programs and files, to the hard disk, and then powers
down completely.
Summary of Contents for 2800-S201
