Toro Z597-D Z Master, Operator'S Manual

Page: 42 / 68

Figure 50
1. Positive Battery Post 3. Red (+) Charger Lead
2. Negative Battery Post 4. Black (-) Charger Lead
Servicing the Fuses
The electrical system is protected by fuses. It
requires no maintenance, however, if a fuse blows
check component/circuit for malfunction or short.
Fuse: Main/Ignition -20 amp, blade-type
Glow plug/Alternator -40 amp, blade-type
1. To gain access to the main fuse, unlatch the
seat and tilt the seat forward. To gain access to
the fan and alternator fuses, raise the seat and
tilt the engine cover forward.
2. To replace a fuse, pull out on the fuse to
remove it (Figure 51).
Figure 51
1. Glow plug/Alternator-
40 amp
2. Main/Ignition-20 amp
Drive System
Maintenance
Adjusting the Tracking
The machine has a knob for adjusting the tracking
located under the seat.
Important:
Adjust the handle neutral and
hydraulic pump neutral before adjusting
the tracking. Refer to Adjusting the Handle
Neutral in Controls System Maintenance,
page 49 and Adjusting the Hydraulic Pump
Neutral in Hydraulic System Maintenance,
page 50.
1. Push both control levers forward the same
distance.
2. Check if the machine pulls to one side. If it
does, stop the machine and set the parking
brake.
3. Unlatch the seat and tilt the seat forward to
access the tracking knob.
Note:
Determine the left and right sides
of the machine from the normal operating
position.
4. To make the machine go right, turn the knob
towards the rightside of the machine. Refer to
Figure 52.
5. To make the machine go left, turn the knob
towards the leftside of the machine. Refer to
Figure 52.
6. Repeat adjustment until the tracking is correct.
Figure 52
1. Tracking knob 4. Turn this way to track right
2. Hydraulic tank 5. Turn this way to track left
3. Hydraulic pumps
42