Toro Z597-D Z Master, Operator'S Manual

Page: 18 / 68

2. Lower the roll bar to the down position. There
are two down positions. See Figure 6 for the
positions.
3. Install the two pins and secure them with the
hairpin cotter pins (Figure 7).
Figure 6
1. Full down position 2. Down position with bagger
installed
Important:
Ensure that the rear part of
the seat is secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter
pins and remove the two pins (Figure 7).
5. Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins (Figure 7).
Important:
Always use the seat belt with
the roll bar in the raised position.
Figure 7
1. Roll bar 3. Pin
2. Raised position
4. Hairpin cotter pin
Think Safety First
Please read all safety instructions and symbols
in the safety section. Knowing this information
could help you or bystanders avoid injury.
18