•
Cleans the engine while it runs
•
Eliminates gum-like varnish buildup in the fuel
system, which causes hard starting
Important:
Do not use fuel additives
containing methanol or ethanol.
Add the correct amount of gas
stabilizer/conditioner to the gas.
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline. To
minimize the chance of varnish deposits in the fuel
system, use fuel stabilizer at all times.
Filling the Fuel Tank
Note:
If the fuel has been totally run out of the
machine, make sure both fuel tanks are half full
when starting the machine. This will prevent air
getting into the fuel system and causing starting
problems.
1. Shut the engine off and set the parking brake.
2. Clean around each fuel tank cap and remove
the cap.
3. Add unleaded regular gasoline to both fuel
tanks, until the level is 1/4 to 1/2 inch (6 mm
to 13 mm) below the bottom of the filler neck.
This space in the tank allows gasoline to
expand. Do not fill the fuel tanks completely
full.
4. Install fuel tank caps securely.
5. Wipe up any gasoline that may have spilled.
Checking the Engine Oil
Level
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer
to Checking Oil Level in Engine Maintenance,
page 29
Think Safety First
Please read all safety instructions and symbols
in the safety section. Knowing this information
could help you or bystanders avoid injury.
Operating on wet grass or steep slopes can
cause sliding and loss of control.
Wheels dropping over edges can cause
rollovers, which may result in serious injury,
death or drowning.
To avoid loss of control and possibility of
rollover:
•
Do not operate near drop-offs or near
water.
•
Do not operate on slopes greater than
15 degrees.
•
Reduce speed and use extreme caution
on slopes.
•
Avoid sudden turns or rapid speed
changes.
Figure 7
1. Safe Zone-use the Z Master here on slopes less than
15 degrees or at areas.
2. Use walk behind mower and/or hand trimmer near drop-offs
and water.
3. Water
15
Summary of Contents for Z334 Z-Master
Page 8: ...Slope Chart 8 ...
Page 44: ...Figure 53 1 Keep the end of the bolt ush with the nut 3 Nut 2 Rear pivot bracket 4 Bolt 44 ...
Page 54: ......
Page 55: ......