g029644
g027477
Figure 53
Note:
Ensure the oil filter gasket touches the
engine and then an extra 3/4 turn is completed.
3.
Fill the crankcase with the proper type of new
oil; refer to
Changing the Engine Oil (page 41)
.
Servicing the Spark Plugs
Service Interval:
Every 100 hours
Make sure that the air gap between the center
electrode and the side electrode is correct before
installing each spark plug. Use a spark-plug wrench
for removing and installing the spark plugs and a
gapping tool/feeler gauge to check and adjust the air
gap. Install new spark plugs if necessary.
Type :
NGK
®
BPR4ES or equivalent
Air Gap:
0.76 mm (0.030 inch)
Removing the Spark Plug
1.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
2.
Disengage the PTO, move the motion-control
levers to the neutral-locked position, and engage
the parking brake.
3.
Remove the left hydraulic-unit shroud in the
order listed in
.
Note:
This gives you access to the front spark
plug.
42
