Toro Z Master 74925TE, Operator'S Manual

Page: 25 / 72

4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired and,
insert the pin (Figure 26).
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
Figure 26
1. Deck lift pedal 3. Transport lock
2. Cut of height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade control switch (PTO), move
the motion control levers to the neutral locked
position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
Figure 27
1. Anti-scalp roller 4. Flange Nut
2. Spacer 5. Bolt
3. Bushing
Figure 28
1. Anti-scalp roller 3. Flange Nut
2. Bushing 4. Bolt
Figure 29
1. Anti-scalp roller 4. Flange Nut
2. Spacer 5. Bolt
3. Bushing
25