CHASSIS
3-20
Toro Z Master G3 3000/5000/6000 Series Service Manual
3
Park Brake Handle Installation (2012 &
Later)
2. Install the clevis ends of the right and left brake
cables to the parking brake handle assembly using
two clevis pins and cotter pins (Fig. 072).
1. Install the left and right brake cables in the slots in
the bottom of the brake pivot assembly and install
the e-rings (Fig. 071).
Fig. 071
DSCN-2627a
Fig. 072
DSCN-2635a
3. Install two screws through the park brake handle,
two spacers, and tighten the assembly to the frame
(Fig. 073).
Fig. 073
DSCN-2637a
4. Plug the wire harness to the park brake switch.
5. Install the two screws retaining the right hand
motion-control cover assembly to the frame and
tighten (Fig. 074).
Fig. 074
DSCN-2614a
6. Operate the park brake handle to make sure
everything is moving freely.
