CHASSIS
3-18
Toro Z Master G3 3000/5000/6000 Series Service Manual
3
7. Install the throttle cable under the throttle clamp.
Install the throttle Z-bend in the middle hole on the
throttle arm assembly (Fig. 064).
Fig. 064
DSCN-4279a
Park Brake Handle Assembly
Replacement (2012 & Later)
Park Brake Handle Removal (2012 & Later)
1. Remove the two screws retaining the right hand
motion control cover assembly to the frame and
remove the cover (Fig. 066).
Fig. 066
DSCN-2614a
2. Unplug the wire harness from the park brake switch
(Fig. 067).
Fig. 067
DSCN-2617a
9. Move the throttle control back and forth checking the
operation of the throttle arm assembly.
10. Connect the negative battery cable to the battery.
8. Move the throttle arm assembly to the low idle
position and tighten the throttle cable clamp (Fig.
065).
Fig. 065
DSCN-4281a
