CHASSIS
3-40
Toro Z Master G3 3000/5000/6000 Series Service Manual
3
12. Hold the end of the threaded rod with a tool and
adjust the lock nut until the spring length is between
1-1/2” and 1-9/16” (3.8 and 4.0cm) (Fig. 145).
Note: Do not allow the cable to turn when the nut
are being turned.
Fig. 145
DSCN-4315a
16. Plug the wire harness to the park brake switch (Fig.
146).
13. Disengage the parking brake. Rotate the drive wheel
release handle to the released position. Turn the
wheel hub by hand in both directions relative to the
caliper; no drag of the caliper pad on the wheel hub
is desired.
14. After adjusting the brake, cycle the brake handle a
minimum of six times to allow the cable to seat into
the sheath and mounting tabs. Recheck the spring
length.
15. Rotate the drive wheel release handle to the
operating position.
Fig. 146
DSCN-2617a
18. Install the rear tires and torque lug nuts between
103.5 – 126.5 ft-lbs. (140.5 – 171.5 Nm).
19. Remove the jack stands and lower the unit.
17. Install the two screws retaining the right hand
motion-control cover assembly to the frame (Fig.
147).
Fig. 147
DSCN-2614a
