Right Console Installation (continued)
6. Install the hourmeter onto the RH side pod.
7. Connect the wiring harness from the hourmeter.
8. Install the light switch, if applicable.
9. Install the choke cable onto the machine.
Replacement (page 5–16)
10. Install the throttle cable onto the machine.
Replacement (page 5–15)
11. Install the RH side pod onto the RH console. Install the 4 (1/4-20 inch) torx
screws securing the RH side pod to the RH console.
g346220
Figure 27
12. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Left Console Replacement
Left Console Removal
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the 4 (1/4-20 inch) torx screws securing the LH side pod to the LH
console. Remove the LH side pod from the LH console.
Note:
3 screws are shown in the image below.
4000 Series Z MASTER® Service Manual
Page 5–13
Chassis: Service and Repairs
3442-427 Rev A
Summary of Contents for Z Master 4000 Series
