Stability Data
The following tables list the maximum slope recommended for the traction unit in the positions listed in the tables. Slopes over
the listed degree may cause the traction unit to become unstable. The data in the tables assume that the loader arms are fully
lowered; raised arms may affect the stability.
In each attachment manual is a set of 3 stability ratings, 1 for each hill position. To determine the maximum slope you can
traverse with the attachment installed, find the degree of slope that corresponds to the stability ratings of the attachment.
Example: If the attachment installed on a TX 427 traction unit has a Front Uphill rating of B, a Rear Uphill rating of D, and a
Side Uphill rating of C, then you could drive forward up a 20° slope, rearward up a 12° slope, or sideways on a 14° slope, as
listed in the following table for the TX 427 traction unit.
Model 22342HD
Maximum Recommended Slope when
Operating with:
Front Uphill
Rear Uphill
Side Uphill
Configuration
Traction unit without attachment
11°
21°
19°
Traction unit with an attachment rated with one of the following stability ratings
for each slope position:*
A
25°
25°
20°
B
20°
20°
18°
C
17°
17°
14°
D
10°
12°
9°
E
5°
5°
5°
Stability with a Loaded Bucket
For TX Traction Units or Wheeled Traction Units without a Counterweight
B
D
B
For Wheeled Traction Units with a Counterweight
B
D
C
Stability with an Unloaded Bucket
For TX Traction Units or Wheeled Traction Units Without a Counterweight
D
C
C
For Wheeled Traction Units with a Counterweight
D
B
B
7
Summary of Contents for TX 427 22342HD
Page 49: ...Schematics g013124 Electrical Schematic Rev B 49...
Page 50: ...Hydraulic Schematic Rev A 50...
Page 51: ...Notes...
