G010344
1
2
3
4
5
6
Figure 72
1.
Washout fitting locations
on 54 inch decks
4.
O-ring
2.
Washout fitting locations
on 60 inch decks
5.
Hose
3.
Washout fitting
6.
Coupling
4. Lower the mower to the lowest height-of-cut.
5. Sit on the seat and start the engine. Engage the blade
control switch and let the mower run for one to
three minutes.
6. Disengage the blade control switch, stop the engine,
and remove the ignition key. Wait for all moving
parts to stop.
7. Turn the water off and remove the coupling from
the washout fitting.
Note:
If the mower is not clean after one washing,
soak it and let it stand for 30 minutes. Then repeat
the process.
8. Run the mower again for one to three minutes to
remove excess water.
A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact. Contact with blade or thrown
debris can cause injury or death.
•
Replace broken or missing washout fitting
immediately, before using mower again.
•
Never put your hands or feet under the
mower or through openings in the mower.
Waste Disposal
Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
49
Summary of Contents for TITAN ZX6050
Page 11: ...117 1164 1 Fuel 2 Full 3 Half 4 Empty 11...
Page 53: ...Schematics G012083 Wire Diagram Rev A 53...
Page 54: ...Notes 54...
Page 55: ...Notes 55...
