Toro titan mx, Service Manual

Page: 81 / 108

MOWER DECK
6-15 Toro TITAN 2014 Service Manual
6
A blade that is bent or damaged could break apart
and could seriously injure or kill you or bystanders.
• Always replace bent or damaged blades with
a new blade
• Never file or create sharp notches in the edges
or surfaces of blade
a. If the difference between A and B is greater than
1/8” (3mm) replace the blade with a new blade as
outlined in this chapter.
• Recheck, starting at step 1.
Note: If a bent blade is replaced with a new one and
the dimension obtained continues to exceed
1/8” (3mm), the blade spindle shaft could be
bent.
b. If the variance is within constraints, move to the next
blade.
Repeat this procedure on each blade.
Mower Deck Leveling
Check to ensure the mower deck is level any time you
install the mower or when you see an uneven cut on
your lawn.
The mower deck must be checked for bent blades
prior to leveling; any bent blades must be removed and
replaced; refer to “Checking for Bent Blades” as shown
in this chapter.
The mower deck must be leveled side-to-side first then
the front to rear slope can be adjusted.
Requirements:
• The machine must be on a flat level surface.
• All four tires must be properly inflated.
!