Toro titan mx, Service Manual

Page: 80 / 108

MOWER DECK
6-14 Toro TITAN 2014 Service Manual
6
4. Rotate the same blade 180 degrees so that the
opposing cutting edge is now in the same position
(Fig. 102).
3. Measure from the tip of the blade to the level surface
(Fig. 101).
5. Measure from the tip of the blade to the level
surface. The variance should be no more than 1/8”
(3mm) (Fig. 101).
Checking for Bent Blades
Note: The machine must be on a level surface for
the following procedure.
1. Raise deck to the highest height-of-cut position.
2. While wearing thickly padded gloves or other
adequate hand protection slowly rotate blade to
be measured into a position that allows effective
measurement of the distance between the cutting
edge and the level surface the unit is on (Fig. 100).
Fig. 100
fig. 39 G009679
A. Deck C. Blade
B. Spindle housing
A B
C
Fig. 101
fig. 40 G009680
A. Blade, in position for measuring
B. Level surface
C. Measure from blade tip to level surface
A
B
C
A. Blade, side previously measured
B. Measurement position used previously
C. Opposing side of blade being moved into measure-
ment position
Fig. 102
fig. 41 G009681
A
B
C