Toro titan mx, Service Manual, Page: 44 / 108

CHASSIS
3-24 Toro TITAN 2014 Service Manual
3
6. Remove all of the clips and washers (E), then
remove the (3) linkage rods from the chassis.
7. Remove the (2) cotter pins (F), (2) washers and (2)
bushings (G) from the brake bell crank (H)
(Fig. 044).
Fig. 042 PICT-3011
5. Remove the brake return spring (C) and the clip and
washer (D) from the brake rod on the hydro
(Fig. 043).
Fig. 043
PICT-3030
Fig. 044
PICT-3018
8. Slide the brake bell crank (H) to one side and
remove the bell crank from the frame.
9. Inspect all linkage rods, pivot points and bushings
for excessive wear, replace if necessary.
Parking Brake & Linkage Service
Parking Brake & Linkage Removal
1. Tilt seat forward, disconnect and remove the battery.
2. Remove the LH control cover to access the parking
brake handle area.
3. Remove the parking brake pin and washer (A).
Remove the parking brake link from the handle stud.
4. Remove fastener (B) that secures the parking brake
handle to the control box assembly. Remove the
handle from the unit (Fig. 042).
A
B
D
C
F