Toro Sand Pro 140-0274, Installation Instructions

Page: 1 / 4

Form No. 3440-384 Rev A
Drag Mat Kit
Sand Pro ® Traction Unit
Model No. 140-0274
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description Qty. Use
Weight kit 100-6442
Not
included
Front lift frame kit 08712
Not
included
Install the weights to the machine (Models 08703, 08705,
08743, or 08745) or the front lift frame (Models 08705 or
08745 only).
Drag mat 1
Chain 1
Screw (5/16 x 1-1/2 inches) 1
Locknut (5/16 inch) 1
Install the chain to the drag mat.
Left cradle 1
Right cradle 1
Bolt (3/8 x 1-3/8 inches) 4
Flange nut (3/8 inch) 4
Washer (3/8 inch) 4
Shackle 1
Clevis pin 1
Hairpin cotter 1
Install the cradles.
Important:
For traction unit Models 08703 or 08743, you must install weight kit 100-6442 before
operating this attachment.
Important:
For traction unit Models 08705 or 08745, you must install either weight kit 100-6442 or front
lift frame kit 08712 before you operate this attachment.
Important:
You must install a finish grader on the rear of the machine before the drag mat can
be installed.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3440-384* A