Gear Box Assembly
g220501
Figure 394
1.
Input shaft
3.
Button-head screw
5.
Clevis pin
2.
Rear roller brush drive shield
4.
Groomer drive box assembly
6.
Cotter pin
Note:
The groomer gear box assembly is located on the opposite side of the
cutting unit from the cutting unit hydraulic motor.
Removing the Gear Box Assembly
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, shut off the engine, set the parking brake, and
remove the key from the key switch.
2. Remove the groomer reel assembly; refer to
(page 11–13)
.
Note:
If the cutting unit is equipped with an optional powered rear roller
brush, remove the rear roller brush cover, drive belt, and drive housing
assembly to service the groomer drive; refer to
(cutting units with painted side plates) (page 9–51)
for additional information.
CAUTION
Contact with the reel or other cutting unit parts can result in personal
injury.
Use heavy gloves when handling the cutting reel.
3. Safely prevent the reel from rotating by blocking the cutting reel with a piece
of wood near one of the reel spiders.
4. If installed, remove the rear roller brush drive shield from the gear box.
Universal Groomer (Optional): Service and Repairs
Page 11–6
Reelmaster
®
5410/5510/5610 Series
15216SL Rev C
Summary of Contents for Reelmaster 5510 Series
