13
Set Up
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
QTY.
USE
Fuel tank
Bolt 5/16 x 7/8 in. (22.5 mm)
Lock washer 5/16 in.
Washer 5/16 in.
Stud
Spring
Hose clamp
1
2
2
4
2
2
1
Install fuel tank and fuel line
Upper handle
Flanged bolt 3/8 x 1 in. (26 mm)
Flange nut 3/8 in.
1
4
4
Install upper handle to frame
Clevis pin
Washer
Hairpin cotter
1
1
2
Install control rods
Hairpin cotter pin
2
Install hairpin cotter pins
Operator’s Manual
Engine Operator’s Manual
Parts Catalog
Registration card
1
1
1
1
Read before operating machine
Read before operating machine
Fill out and return to Toro
Installing Fuel Tank and Fuel
Line
1. Align fuel tank to top of rear frame and secure fuel
tank right side with 2 bolts (5/16 x 7/8 in.), 2 lock
washers (5/16 in.) and 2 washers (5/16) (Fig. 2).
2. Secure fuel tank left side to frame with 2 studs (5/16 x
7/8 in.), 2 washers (5/16 in.), 2 springs and 2 locknuts
(5/16 in.) (Fig. 2).
Note: Tighten left side until it is completely tight and then
unscrew locknut one full turn. This will allow the spring
to work.
