1
Refer to the illustrated Parts Catalog for the de-
tails of parts used in assembling the Workman
Spreader Frame Kit.
NOTE: Right, Left, Front and Rear are
reference while seated in the operators posi-
tion.
1.
Install the TORO APU Electric Clutch Kit as
per the instructions provided with that kit.
2.
Remove top and sides of crate. Remove the
lag screw at the Frame Mounting Bracket to re-
move the Crate skid.
NOTE: The optional Flow Control Kit (Model
No. 41403) should be installed on the PA-17
Spreader BEFORE the Spreader is attached
to the mounting frame. (FIG. 1) See the Set-
Up and Parts Catalog furnished with the Flow
Control Kit for the installation instructions.
3.
Remove the Drive Shaft Cover and position
the Spreader onto the Mounting Frame.
4.
Use lacquer thinner to remove the rust pre-
ventative coating from the Spreaders in-put shaft
and keyway. Insert the 1/4" square key into the
in-put shaft. See FIG. 1.
FIG. 1
1. Spreader In-Put Shaft
3. Optional
Flow
2. End Yoke
Control
5.
Align the Spreader in-put shaft with the End
Yoke and slide the Spreader forward until the End
Yoke is fully engaged on the in-put shaft. DO
NOT TIGHTEN the set screw at this time.
FORM NO. 92-8237 REV. A
MODEL NO. 41252-90001 & UP
PA-17 WM FRAME KIT & SPREADER
FOR THE WORKMAN
R
VEHICLE
SET-UP AND
PARTS CATALOG
6.
Loosen the fasteners on the Frames mount-
ing straps and align the hole in the Spreaders
rear mounting plate with the hole in the Mount-
ing Frame as shown in FIG. 2. Insert a 5/8" x 2"
bolt with washer through the holes to maintain
the alignment of the Spreader in-put shaft and
End Yoke
.
FIG. 2
1. Rear Mounting Plate
2. U-Bolts
7.
Align Frames mounting mounting straps with
the mounting lugs on the front of the Spreader.
Secure the Spreader to the straps with two 5/8" x
2-1/2" bolts, eight washers and two hex nuts. See
FIG. 3. Re-tighten mounting straps fasteners.
1. Mounting Straps
3. Cross Member
2. Mounting Lugs
FIG. 3
1398
1399
©The TORO Company - 1999
All Rights Reserved
1397
