Lift/Lower Circuit Problems
Problem
Possible Causes
The gear pump is noisy (cavitation).
• The hydraulic-fluid level in the hydraulic tank is low.
• The hydraulic fluid is very cold.
• The suction line is restricted.
• There are air leaks in the suction line.
The cutting deck (or implement) does not lift or lifts slowly.
• The engine speed is too low.
• The lift cylinder linkage is binding or broken.
• The lift arm bushings are binding.
• The hydraulic-fluid level in the hydraulic tank is low.
• The gear pump pressure or flow is insufficient.
• The gear pump is damaged.
• The implement-relief valve (in the gear pump) is stuck open.
• The lift cylinder is leaking internally.
• The lift control manifold is damaged.
The cutting deck (or implement) raises, but does not stay up.
• The lift cylinder is leaking internally.
• The lift control manifold is worn or damaged.
Hydraulic System: Troubleshooting
Page 4–30
Groundsmaster 7210
16222SL Rev C
Summary of Contents for Groundsmaster 7210
